Friday, September 17, 2010

The Pulley

Back from Dick's shop, the pulley is perfect!!

The pulley with internal spacer should mount on the existing water pump pulley and slow the the fan to a reasonable speed that will prevent damage should I have to wind'er up a little. This is a  CVF Racing part
# BBFL1WP pulley that has the center hole bored to .980" and the 54' bolt pattern (2.25") added to the mounting flange. The spacer is installed internally between the new pulley and the existing pressed on 54' water pump pulley.
This is going to require a little time to install, and I will report back on the operation.

Thanks again, Dick.

No comments:

Post a Comment